<address id="gnjbi"><strike id="gnjbi"><dl id="gnjbi"></dl></strike></address>
      <noscript id="gnjbi"></noscript>
      <source id="gnjbi"><var id="gnjbi"></var></source>
      <pre id="gnjbi"></pre>
        <optgroup id="gnjbi"><wbr id="gnjbi"></wbr></optgroup>

        <ol id="gnjbi"></ol>
          <ruby id="gnjbi"></ruby>
          1. 歡迎來到洛陽星利達熱力設備有限公司 聯系我們 | 在線留言 | 網站地圖
            銷售熱線:18637901191(丁經理)

            熱門搜索: 翅片管 不銹鋼翅片管 翅片管式換熱器 電力除渣設備 電力給煤設備

            翅片管知識動態當前位置:翅片管官網主頁 > 新聞中心 > 翅片管知識動態

            翅片管式換熱器的日常維護方法

            發布時間:2019-03-22 作者:洛陽星利達熱力設備有限公司

            翅片管式換熱器的日常維護方法

              無論是哪種翅片管式換熱器,在日常使用中都要進行合理的保養與維護,方能保證換熱器的正常使用,延長換熱器的使用壽命。那么,既然如此,我們該如何對換熱器設備進行維護呢?

                   No matter which kind of fin-and-tube heat exchanger, reasonable maintenance and maintenance should be carried out in daily use to ensure the normal use of the heat exchanger and prolong the service life of the heat exchanger. So, in this case, how do we maintain the heat exchanger equipment?

                   不銹鋼翅片管換熱器.jpg


              1、翅片管式換熱器要壓緊螺帽與上下導桿,并經常加注潤滑油脂進行潤滑;

                   1. The finned tube heat exchanger should press the nut and the upper and lower guide rods, and often add lubricating grease for lubrication;


              2、在更換換熱器的傳熱片橡膠墊圈時,要將該段全部更新,以防各片間隙不均,影響其傳熱效果,一般情況下,在操作開始使用清水進行循環時,可能會有輕微的漏泄,直至溫度升到殺菌溫度時,漏泄才會自行消失,如果這時漏泄仍不停止,就需要將傳熱片再壓緊一些,如果仍不見效,就需要打開檢查橡膠墊圈的情況,很可能是傳熱片沒按號碼順序排列所致,要予以糾正。

                 2. When replacing the heat transfer rubber gasket of the heat exchanger, the section should be completely updated to prevent the unevenness of the gaps of each piece, which affects the heat transfer effect. Under normal circumstances, when the operation starts using water to circulate, it may be There will be a slight leak, until the temperature rises to the sterilization temperature, the leakage will disappear by itself. If the leakage still does not stop, the heat transfer sheet needs to be pressed again. If it still does not work, you need to open the inspection rubber gasket. In the case, it is likely that the heat transfer sheets are not arranged in the order of numbers and should be corrected.


              3、定期對換熱器的各傳熱片進行清洗,是否存在沉積物、結焦、水銹層等結垢附著,并及時進行清洗。同時,還要經常性檢查翅片管式換熱器各傳熱片與橡膠墊圈的粘合是否緊密,完好。

                   3. Regularly clean the heat transfer sheets of the heat exchanger, and whether there are deposits such as deposits, coking, and rust layers, and clean them in time. At the same time, it is necessary to constantly check whether the heat transfer sheets of the fin-and-tube heat exchanger are closely bonded to the rubber gaskets and are in good condition.


              4、換熱器的各儀表調節都需要由專人負責,并且要嚴格執行操作規程進行操作與維護。

                   4. The adjustment of each meter of the heat exchanger needs to be handled by a special person, and the operation rules must be strictly implemented for operation and maintenance.


              翅片管有效的維護與保養是保證換熱器正常工作的關鍵,更是延長其使用壽命的基礎。

                  The effective maintenance and maintenance of the finned tube is the key to ensure the normal operation of the heat exchanger, and it is the basis for extending its service life.


            版權所有:洛陽星利達熱力設備有限公司 備案號:豫ICP備19005217號-1   技術支持:青峰網絡

            洛陽星利達熱力設備有限公司是一家專注于生產銷售:翅片管、不銹鋼翅片管、翅片管式換熱器、燃氣爐專用翅片管等換熱元件的翅片管廠家。